Cisco CCNA Packet Tracer Ultimate Labs: CCNA Exam Preparation Labs – Part 1

Cisco CCNA Packet Tracer Ultimate Labs: CCNA Exam Preparation Labs – Part 1
Cisco CCNA Packet Tracer Ultimate Labs: CCNA Exam Preparation Labs – Part 1
English | MP4 | AVC 1920×1080 | AAC 48KHz 2ch | 12h 40m | 2.77 GB

Are you ready for the CCNA exam? Check your knowledge with our CCNA Exam Prep Labs. Make sure you are preparing for ICND1, ICND2 or CCNA exams.

Get the hands-on experience to pass your CCNA exam! Make sure you are ready to pass the CCNA exam! Prepare practically for the Cisco CCNA certification which is the most in-demand networking certification in the world today! Make sure you can pass the Cisco CCNA Routing and Switching 200-125 exam! This course tests your knowledge of CCNA topics with practical, hands-on labs. Labs include both configurations as well as troubleshooting labs.
Start your journey today learning about networking.
Section 2 – Download, Installation, and Introduction to Cisco Packet Tracer
Section 3 – Basic Cisco Configuration Lab covering configurin host names, IP addresses, creating and encrypting an enable password, configuring the lines, ensuring basic connectivity between two routers, as well as telnet access
Section 4 – Life of a Packet Quiz – Uses Packet Tracer’s Simulation Mode to gather the information necessary to answer the quiz questions listed in the topology diagram. It shows what changes are made to a packet from source to destination as it’s processed by L2 and L3 devices, as well as changes between L2 data-link encapsulated frame types.
Section 5 and 6 – Subnetting Lab 1 – Subnet an intial IPv4 allocation to support 4 smaller subnets, configure the routers, switches, and DHCP servers per the instructions, as well as testing client PC connectivity to remote web servers.
Section 7 and 8- DHCP Server Lab 1 – Configure a DHCP server on a router, and test with a PC. (single VLAN)
Section 9 – Router on a stick – Configure a router to perform inter-VLAN routing for clients connected to a switch. Tasks include configuring subinterfaces on the router, creating VLANs on the switch (along with a single SVI), establish a trunk between the router and switch, and confirm connectivity with client PCs.
Section 10 – Broadcast and Collision Domains – A quiz lab, where you gather information by using Packet Tracer’s sumulation mode, to correctly answer the questions. Covers ARP, Broadcast Domains, Collision Domains, differences between Hubs and Switches.
Section 11 – Basic VLANs in a Campus Network – Covers Intervlan routing, creating multiple VLANs and SVIs, configuring trunk links and access ports appropriately.
Section 12 – VTP Configuration Lab – Covers VTP options and configuration, including password, domain name, and operational modes.
Section 13 – VTP Troubleshooting Lab – Example network has issues with VTP clients not synchronizing their vlan databases to the VTP server. Students must investigate and correct multiple problems.
Section 14 – Disable Spanning-tree? – Students use Packet Tracer’s simulation mode to see what occurs when disabling STP on two switches connected by two links (L2 loop is induced on purpose, to reinforce the importance of STP on switched networks.

An exhaustive course packed with step-by-step instructions, working examples, and helpful advice. This course is divided into clear chunks so you can learn at your own pace and focus on your own area of interest

What You Will Learn

  • Be prepared for the CCNA exam
  • Verify your knowledge of CCNA exam topics
  • Ace the CCNA Exam simulations
  • Pass the CCNA or CCENT exams